Select the cell of the command you want to send and press the "Send Command" button.Enter the interface number (#1 to #6) in the cell to the left of the command.#1 to #3 and #4 to #6 can be switched by pressing. The case where you want to use multiple interfaces When the "Use EOI" checkbox is checked, the EOI (End Of Identify) is controlled when sending and receiving commands.ĭetailed settings for GPIB communication. When "Device clear when connected" is checked, SDC (Selected Device Clear) will be sent when connected. Select the character encoding to be used for sending and receiving.Ĭhoose between "ASCII", "UTF-8", and "Shift-JIS".ĭetailed settings for RS-232C/USB communication.ĭetailed settings for National Instruments GPIB communication. Selects the terminator to be added when sending a command.Ĭhoose between "NONE", "CR+LF", "CR", and "LF". Launching the interface options allows you to make detailed settings.Ĭheck the specifications of the device to be communicated with, and make settings. You may be able to communicate by entering the VISA address directly.Īlso, check the device manager to make sure that the device used for communication is properly recognized. If the VISA address does not appear in the list after pressing the , Select the VISA address you want to use, or enter the VISA address directly. Press the to update the list of VISA addresses.of the GPIB board to be used.īefore using VISA, please install Keysight IO Libraries Suite or NI-VISA. When communicating using a CONTEC GPIB controller To open the Device Manager, click in the Tools section of Sequence Maker. If communication is not possible, check in the Device ManagerĪnd make sure that the device is recognized correctly. Select the device address of the device to communicate with.Select the ID (GPIB interface ID) of the GPIB board to be used the GPIB board ID can be found in NI MAX.When communicating using a GPIB controller manufactured by National Instruments To open the network settings, click on in the Sequence Maker tools. In order to communicate correctly, the IP address of the computer must also be set properly. Enter the port number of the device to communicate with.Enter the IP address of the device to be communicated with.When using a USB connection, make sure that the necessary USB drivers have been installed correctly. To open the Device Manager, click the in the Sequence Maker tools. If the COM port does not appear in the list after pressing the ,Ĭheck in the Device Manager to make sure that the device is recognized correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |